Afikim Caddy Manuel d'utilisateur télécharger pdf (Page 20)

Caddy

2.3 Fixing the tiller to the frame

The tiller (b - in figure 1) must be fixed to the frame (a - in figure 1).

Refer to figure 3: The frame bushing (1) is inserted onto the tiller

tapered block (2) . It is also the fixation of the tiller to the frame by

means of a locking lever (3).

We advise you to approach the frame from the left hand side (when you

are right-handed. Take the tiller in your left hand, holding it at the frame

tube just above the control panel. Make sure you hold it up straight and

tilt it backwards slightly as indicated in figure 3.

Lift the frame bushing (1) by mean of the lever (3) using your right hand

as shown in figure 3 . Now place the frame bushing over the tapered

block (2) of the tiller. Than after they attached together push the lever

(3) forward and downward until it lock them together . Make sure that

you hear a clicks that will ensure you completely secured connection.

Please refer to figure 3 to the differences between the two positions :

Released and Secured . Also make sure that the connection is done

properly by means of tilting the tiller forward and backward .

The electrical connections between the tiller and the frame is done at

the same stage .

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 77 78

Pas de commentaire

Afikim Caddy Manuel d'utilisateur Page 20